Clarion DXZ-835MP

The factory deck is out, and the wiring of the Clarion deck is the next topic.  Sadly, there wasn't a proper Subaru wire Harness adapter available, so I took a different one, reloaded all the wires and we are off to the races...

	Here is a close-up of the stock plug
	The reloaded wire harness adapter ready to drop be connected to the Clarion wire harness
	The Clarion harness and the adapter on the samewhat cluttered, but quite famous test bench!
	Slide the heat shrink onto one end before making a mechanical connection.
	Make your mechanical connection.  This is the key to a good solder connection
	Now, heat the wires from below and allow the solder to flow into the joint.
	Repeat with all the other wires
	Slide the heat shrink into place, and use a heat gun to wrap things up tight.

Here is the last set!